Skip to content
Monday – Friday: 7 a.m. – 5:30 p.m. · Saturday: 8 a.m. – 12 p.m. · Sunday: ClosedMonday – Friday: 7 a.m. – 5:30 p.m.(719) 555-0100

What we replace

Six jobs, one way of working

Every job follows the same steps: a visit, a load calculation, a written quote, a permit, an install and a start-up test. The points under each job are what moves its price.

  • Gas furnaces

    The main job here. We size the furnace to the house, set the input for your elevation and check the vent and the gas line.

    • Fuel and input size

    • Efficiency level and one-stage or variable speed

    • Venting: existing flue, liner or sealed vent

    • Gas line and shutoff

    • Coil match, if there is cooling

  • Air conditioners

    For houses with ducts. We size from the load, then read the maker's altitude data, and place the outdoor unit with hail in mind.

    • Capacity from the load calculation

    • Efficiency tier and one-stage or variable speed

    • Electrical: breaker, disconnect, wire

    • Pad, line set and where the unit sits

    • Duct condition

  • Heat pumps and dual-fuel

    A cold-climate heat pump, usually with the furnace kept as backup. We tell you where it pays off and where it doesn't.

    • Heat loss of the house

    • Single-zone, ducted or dual-fuel

    • Electrical capacity at the panel

    • Controls that switch between heat sources

    • What your utility or state offers; ask us

  • Whole-system changeouts

    Furnace, coil and outdoor unit replaced together so they are matched, with the ducts looked over.

    • Everything above, once

    • Duct size, leaks and balance

    • Return air and filter location

    • Permit and inspection

    • Old equipment removal

  • Hail guards

    A cage or panels around the outdoor unit, added when we install or to a unit already in place.

    • Guard type and material

    • Unit make and size

    • Clearance the maker requires

    • Install on a new or existing unit

    See the options
  • Thermostats and controls

    The thermostat that fits the equipment, set up and explained before we leave.

    • Equipment it has to control

    • Wiring already in the wall

    • Zoning or a single zone

    • Wi-Fi or a plain programmable model

Before you choose

Repair or replace?

How do I know whether to repair or replace?

Age, the cost of the repair against the cost of a new unit, and how the system has behaved this year are the three things we weigh. If a repair makes sense we say so, and we write down what we found.

Can you install in winter?

Yes. A furnace replacement in winter is planned around keeping the house warm: the crew works room by room, and the old furnace stays until the new one is ready to run.

Do you service brands other than the ones you install?

We repair most makes, but our replacement quotes list the equipment we install. Ask which makes we carry when you call.

Not sure which job you need?

Describe the system you have. We will tell you which of these it is.